Ideeën Ender 3 Z Axis Extension

Ideeën Ender 3 Z Axis Extension. 15/02/2020 · my advice is to leave your ender 3 alone. Extend the capabilities of your creality ender 3 3d printer to an impressive height of 500mm**. Are there parameters in the firmware that i would need to change as well or are the print boundaries set by the slicer only? Read on to find out all about it!

Coolste Aclk Sa L Ai Dchcsewjk Fhgp5x0ahxf4xckhrucdvsyababggjlzg Sig Aod64 2pq6ogeyvp0ol4ce4jtifa1fduza Adurl Ctype 5

I needed a few inches longer heat bed cable so i got the 1 meter extension cable set, the shortest available. I'm assuming i'll just need those, extension cables for the wiring and just change the print boundaries in my slicer program and it should work? New to this so i'm sorry if this is a stupid question. I ended up replacing the stock bed cable with a section of cable from the extension.

Extend the capabilities of your creality ender 3 3d printer to an impressive height of 500mm**.

I've found 400mm rails on ebay. Has anybody tried this before? Are there parameters in the firmware that i would need to change as well or are the print boundaries set by the slicer only? Read on to find out all about it! I ended up replacing the stock bed cable with a section of cable from the extension.

I'm assuming i'll just need those, extension cables for the wiring and just change the print boundaries in my slicer program and it should work?. The only youtube video i could find for it was the actual assembly and nothing to with the. 15/02/2020 · my advice is to leave your ender 3 alone.. I ended up replacing the stock bed cable with a section of cable from the extension.